Frequently Asked Question
Engine not firing, cutting out after start, fuel pump not working
Last Updated 10 years ago
1. Is Basemap loaded?
2. usually fuel pump related. Is FP priming/running when cranking?
9697 Check if it is immobilized, pin change maybe required, HW install guide
8995 : removal of MAF means FP may not be runing, bridge FP to GND in diagnostic connector, as shown in HW install guide
9900 : Is the jumper on the PCB set correct for Fuel Pump - again in HW Install guide.
3. Send Log.
2. usually fuel pump related. Is FP priming/running when cranking?
9697 Check if it is immobilized, pin change maybe required, HW install guide
8995 : removal of MAF means FP may not be runing, bridge FP to GND in diagnostic connector, as shown in HW install guide
9900 : Is the jumper on the PCB set correct for Fuel Pump - again in HW Install guide.
3. Send Log.